Forums - Regarding Thread Border Router Configuration on QCA4020

2 posts / 0 new
Last post
Regarding Thread Border Router Configuration on QCA4020
vinaya.hasyagara
Join Date: 21 Sep 20
Posts: 1
Posted: Mon, 2020-09-21 06:49

Hi,

We are developing an Industrial IoT product using Thread protocol. For this, we are planning to use QCA4020 chip by Qualcomm. We went through some of the documentation by Qualcomm but did not specifically find how to configure QCA4020 as Thread Border Router.

Is there any example code or application note on how to configure QCA4020 chip as thread border router? Also, since it supports both Thread and Wi-Fi, can we run Thread stack and Wi-Fi stack concurrently? If so, how does communication happen between Thread Stack and Wi-Fi stack?

                                                                                                                                 

Please help us with this.

Thnak you

  • Up0
  • Down0
raja_pedada
Profile picture
Join Date: 18 Jun 18
Location: San Jose
Posts: 297
Posted: Mon, 2020-11-09 16:54

Kindly refer to Section 6.3.3.32 Usage examples under QCA402x (CDB2x) Development Kit User Guide
80-YA121-140 Document for Thread initialization examples.

Thread Uses Ot0 interface and Wlan uses wlan iterface.
However,  you can specify IPv6 Default gateway to BorderAgent and start borderagent as described in Example section.

  • Up0
  • Down0
or Register

Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.