Forums - Stack offload mode

2 posts / 0 new
Last post
Stack offload mode
sudeshs108
Join Date: 25 Jun 19
Posts: 1
Posted: Wed, 2019-06-26 04:22

Hi There,

In our embedded appllication using the Renesas Synergy S7G2 MCU, we will be using a WiFi module that has the QCA4002. We need to ensure we use the TC/IP stack on the Renesas Synergy MCU and not use the stack on the QCA4002. 

Please confirm that all firmware versions of the QCA4002 support the ability to disable the stack offload feature?

Also confirm that the QCA4004 also enables one to not use the stack offload?

regards

Sudesh

 

  • Up0
  • Down0
jbhanu Moderator
Join Date: 6 Feb 17
Posts: 76
Posted: Wed, 2019-06-26 21:26

Hi,

Yes, You can enable non-offload mode. QCA4002 would pass all IP packets to MCU when this mode enabled. 

Please refer to section7(Driver Porting guide) in 80-Y9106-1_A_QCA4002_QCA4004_Hosted_MQX1_1_PG.pdf doc  too 

thanks

  • Up0
  • Down0
or Register

Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.