Hi All,
I am developing some device using CSR1013.
In order to test using uEnergyTools_2.5.0 with my PCB, it didn't work.
The error message is:
ERROR: Connection failed (Failed to connect to device (Error detecting chip type (Read failed on USB-SPI)))
Failed to open USB SPI (352847).
With EVM B/D(CNS10004V5D) and USB-SPI Converter(CNS10020V3A), it works well.
But it didn't work with my PCB and [USB to Debug SPI programmer board(H13516V1)]. I can't test with CNS10020V3A converter because my PCB don't have 8-pin connector.
So I tried to test using H12516V1 board.
The connection is :
[My PCB] [H12516V1]
GND ---------- GND
SPI ------------ SPI
MISO --------- MISO
MOSI --------- MOSI
CSB ---------- CSB
CLK ---------- CLK
VBAT -------- 3V0
and I runned uEnergyTest application.
In this program, I can see "SPI Transport" is detected as "USB SPI (352847)". I pressed OK button after I selected "Ptest Firmware Defaults".
The Result was Failed with above Error message.
When I tested with EVM B/D and USB-SPI converter, It works.
Could you telll me what is my mistake?
Hi tongji98,
The thread I put a link to seems to me to discuss about similar problem. Have a look at that https://developer.qualcomm.com/forum/qdn-forums/hardware/bluetooth-conne...
Marek