Hi,
how can I boot the platform from mSD or USB?
I see that it is supported by the platform, but how can I prepare the mSD/USB for this?
thanks,
Hi,
how can I boot the platform from mSD or USB?
I see that it is supported by the platform, but how can I prepare the mSD/USB for this?
thanks,
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
I don't think platform support mSD card/USB boot-up. I will check with team.
Thanks
I don't think platform support mSD card/USB boot-up. I will check with team.
Thanks
Hi,
On "Robotics RB5 Development Kit Hardware User Manual_V1.0" section 8 (boot configuration), there is an explanation about one of the DIP switch's (https://thundercomm.s3-ap-northeast-1.amazonaws.com/shop/doc/1590131656070623/Qualcomm_Robotics_RB5_Platform_Hardware_User_Manual_V1.0.pdf)
as describes there, there is an option to boot up the platform from SD or USB.
We will verify it and get back to you.
Thanks
Kevin
Hi,
any update on this issue?
thanks in advanced,
Benny
Hi Benny,
mSD/USB boot mode could be supported, however current release doesn't support these two boot mode. If you really want to these two boot mode in your project, you can contact our sales guys.