Anyone have a clue what might be wrong with attempting to connect to a QCA4020 using the J-Link mini programmer.
Connecting ...
- Connecting via USB to probe/ programmer device 0
- Probe/ Programmer firmware: J-Link EDU Mini V1 compiled May 18 2022 17:09:10
- Device "CORTEX-M4" selected.
- Target interface speed: 1000 kHz (Fixed)
- VTarget = 3.172V
- TotalIRLen = ?, IRPrint = 0x..000000000000000000000000
- Failed to identify target. Resetting via Reset pin and trying again.
- TotalIRLen = ?, IRPrint = 0x..000000000000000000000000
- Executing init sequence ...
- ERROR: Could not perform target reset
- ERROR: Failed to connect.
Could not perform custom init sequence.
Are the JTAG connections listed
I have corrected the missing 120K pullup resistor on reset
Thank you in advance
Dante
Crud,
Looks like you cannot put images in the posts
How does one put in figures - like schematics snippets for reference
I have a J-Link mini working for a long time know. If you could list how you did connect it I can compare it with my setup