Hi Everyone,
I have downloaded QCLI_demo onto QCA4020 flash. I am now working to show program in terminal through UART communication. I have followed the guide in setting the board pin to allow Debug UART configuration by connecting J18, J19, J91 and J92 pins but I did not see any output on terminal. Is there more configuration I need to make? Thank you
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
Kindly make sure you are using the supported gcc version 6.2