Hi,
I need to cutoff power from Li-Ion battery @2.5V.
This is for under voltage protection of the cell. Which would be the cheapest approach?
Any way to configure VDD_BAT?
Regards,
Kart
Hi,
I need to cutoff power from Li-Ion battery @2.5V.
This is for under voltage protection of the cell. Which would be the cheapest approach?
Any way to configure VDD_BAT?
Regards,
Kart
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
May be BatteryReadVoltage() could be of some help to you.
It helps to measure input voltage of CSR1010.
Then at 2.5 volts, using a GPIO, you can switch OFF a transistor connected in series between the battery and CSR1010. (Take care of VCE voltage)
I dont think it is possible to configure VDD_BATT.
Regards.
Yes, we cannot use software solution, what could be the cheapest hardware soultion.
Thanks Dr Nissim, I think it is a feasable option.