Using the stock demonstration CSRMeshLight application:
I notice that the green LED illuminates brightly before AppInit is called by the CSR system. This would imply that the port is being pulled low rather than floating. Is there a way to define the state of PIO pins before the application code is called?
Are you running mesh on the CSRB534x hardware? If not and you are using the CSRmesh Development Kit please use the relevant forum at https://developer.qualcomm.com/forums/hardware/bt/csr101x.
On electric moment, PIO10 connection LED will flash once
Why the LED connect with PIO10 will flash once when power on reset ?
Please advise which hardware platform and which chip you are using?
Base on CSRmesh development kit, when I would like to switch off or change to green, where is the modify point in the CODE(CSRMeshLight)? Is that part fixed in the libraries?