I have couple of questions regarding the Freedom/Ardiuno Connector. I am assuming the Freedom/Arduino pin out SP140 will be same as K22 MCU as mentioned in the following link (Page 16 / Section 15 - Input/output connectors)
Is my assumption right ? Because the the 5V output and GND is *NOT* as per the document. I could *NOT* find the 5v output and GND. It will be of great help if you please give the pinout details of Freedom/Arduino connector as well. Thanks in advance
Hi,
Actually the SP140 was intended to connect to a KL25 or a KL26 freedom board . You basiclly can connect a K22 but the mapping will be different.
Since all of them are compliant to Arduino you just need to make sure that you know which MCU pin goes to which header pin.
Pls work with the schematics .
http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=FRDM-KL26Z
http://www.freescale.com/webapp/sps/site/prod_summary.jsp?code=FRDM-KL25Z
The 5V output is connected . - send me an email ([email protected]) and i can send you the excel table as the formatting is not good in the forum copy-paste.