Forums - Advertising / Mesh Message Failure

2 posts / 0 new
Last post
Advertising / Mesh Message Failure
jacook81
Join Date: 10 Aug 16
Posts: 3
Posted: Thu, 2018-02-01 07:25
I am using the CSR1010 with the uEnergy SDK 2.6.3.11 and the mesh library 2.1.h. I'm having a problem that a device will stop communicating in the mesh, and also stop advertising over BLE. The devices advertise 24/7 every 3 seconds, and enable mesh listening every 5 seconds for 250 ms, then disables mesh listening to save power. When they get in this state we have to power cycle them to get them to advertise again.
 
Please advise on what we should do to troubleshoot this issue. Thanks!
 
  • Up0
  • Down0
aircable
Join Date: 8 Jun 16
Location: San Jose
Posts: 25
Posted: Thu, 2018-02-01 10:03

I have seen that problem too. The mesh stops ater a while when using uE2.6. 

We switched back to uE2.5.1 and run Mesh 2.0, this combination seems to be reliable enough.

  • Up0
  • Down0
or Register

Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.