- How can I flashing the firmware on QCA4010 using USB?
- How can I get the ART2 (Atheros Radio Test 2) tool?
Flashing the firmware
Posted: Mon, 2017-12-25 17:26
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
Dear Customer,
1. To flash the firmware to 4010, the 4010 board need to be setup in USB mode by changing the Jumper pin settings on the board.
Please refer the doc: 80-YA673-1 Rev. B, which you can download from createpoint and go to section 2.2.3 Access USB interface in calibration mode.
2. For ART2 tool, you need to dowmnlaod it from createpoint.
Hi Svegesna,
The ART2 tool can't be found at createpoint. Could you suggest any link or place to download ART2 tool?
Dear Customer,
we would suggest you to use JTAG for flashing the image into 4010 board, as ART2 tool access requires few license agreements need to agreed.
Please refer Doc: 80-YA675-2 Rev. A and section 6.4.1 Flashing image via JTAG.
Also refer Doc: 80-YA673-1 Rev. B and section 2.2.2 Access interfaces in JTAG mode, inorder to set the 4010 board in JTAG mode.
Thanks,
Santhosh
Hi Santhosh,
I prefer to use USB because I don't have the tool to use JTAG mode right now.
Please advise.
Hi ,
ART2 is under NDA and can't be discussed on the Public QDN (Qualcomm Development Network)
Is it possible for you to open a salesforce ticket for QCA and we'll be happy to support you.
Regards
jyo