I have to external interrupt source, one is a button which is pulled-up to 3.3V, but another is a wave that directs connect to PIO9 of CSR1010.
Then button press can wake up the chip ,but the edge of the wave can't . does anybody know why? appreciate for your reply!
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
You have to define edge both
PioSetEventMask(BUTTON_PIO_MASK, pio_event_mode_both);
Nissim,thanks for your advice. set eventmask of PIO9 with pio_event_mode_both or pio_event_mode_falling can wake the chip.I'm really amazing that if I set PIO9 of pio_event_mode_rising,then can't wake up. do you know why? or I have missed some settings?
The button you use has pulled up to 3V, so, when pressed it short to GND ( need to anyway)
So it can send only GND to pio9
so wake up can be only by down going down by pressing or up-going by relish the bottom.
call my Skype nissim.test I will explain better.