I want to trigger PIO event in CSR1010 board. I see two switches SW2 and Sw3
But pressing either of the switches does not initiate the required callback event
Is there special software/hardware configuration to be done to enable this
I want to trigger PIO event in CSR1010 board. I see two switches SW2 and Sw3
But pressing either of the switches does not initiate the required callback event
Is there special software/hardware configuration to be done to enable this
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
tskprabhu,
Did you defined the CSR1010 pios connected to SW2,Sw3 as input and
PioSetEventMask(PIOx_MASK, pio_event_mode_both);
Thanks Nissim,
The PIO button was mentioned as 11 in sample application.
Changed it to 1 (as per board schematic) and the sample application is working
Thanks