Are there any tricks or guides to using the UART / serial ports on the APQ835?
I have tried both the USB micro and the UART header (with an FTDI serial cable) and I cannot get any output from the device. Based on my limited knowledge, I should at least be able to watch the device boot.
All I do get, when I execute the command "adb shell reboot" is
<break>
Apologies for using this forum, I couldn't find a more relevant forum.
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
