Forums - pre-install image and uart support

1 post / 0 new
pre-install image and uart support
Join Date: 25 Oct 21
Posts: 2
Posted: Fri, 2021-11-05 11:48

Hey guys,

I have what I hope is a simple question.  I understand the QCA4004 has a pre-installed image in ROM.  Do we know if this image has UART support for AT commands from host? I understant that if you want SPI interface you need to do some pin setup during initialization (bootstrap) but for UART support do i need to flash a new image or the pre-installed image should be enough?

Thanks in advance. 

  • Up0
  • Down0

Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.