Is there a specfic pin that must be used as the pending interrupt signal (SPI_INTR) on the QCA4004 or is it possible to configure any GPIO to allow for interrupts? If it is necessary to configure a GPIO, how would one go about doing this?
Thank you in advance.
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
