Telematics SDK - User Guide
v1.43.0
Home
Related Pages
Related Pages
Here is a list of all related documentation pages:
[detail level
1
2
3
]
Revision History
Introduction
Building Yocto Platform SDK
Using SDK APIs in simulation mode
Steps to writing an App
▼
Sample Apps
Sample Applications Configuration
Configuring Logs from the SDK
▼
audio
Audio Manager API
Audio playback session
Audio capture session
Audio loopback session
Audio tone generation
Audio voice session start and stop
Audio voice session volume/mute control
Audio voice session device switch
Using Audio Manager APIs to play DTMF tone in a voice call.
Using Audio Manager APIs to detect DTMF tones in a voice call.
Audio transcoding operation
Compressed audio format playback
Compressed audio format playback on voice paths
▼
common
Public Logging API
▼
cv2x
C-V2X Get Status Sample App
C-V2X RX Sample App
C-V2X TX Sample App
Setting verification load using C-V2X Throttle Manager API
Obtaining filter rate adjustment notification from C-V2X Throttle Manager API
▼
tel
Make Call
Make eCall
Make Request Voice Service State of the device
Set radio power of the device
Using Request Service Domain Preference API
Using Subscription Manager APIs
Using Card Service APIs
Using SAP APIs
Using Request Network Selection Mode API
Remote SIM Manager API Sample Reference
Using Remote SIM Reference Apps
Sending SMS
Listening to Incoming SMS
▼
data
Start/Stop data call
Get data profile
Get and Set data filter mode
Add data filter
Remove data filter mode
Enable/Disable Firewall
Create Firewall DMZ
Add Firewall Entry
Add a software bridge and Enable software bridge management
Remove a software bridge and Disable software bridge management
Create Vlan And Bind It To PDN
Create Static NAT Entry
Enable L2TP and Add Tunnel
Enable/Disable Socks
▼
loc
Using Location Service APIs
Using Location Configurator APIs
▼
config
How to load and activate modem config file
How to Get and Set Auto Config Selection Mode
How to deactivate and delete modem config file
▼
power
Using TCU Activity Manager APIs to get TCU activity state updates
Using TCU Activity Manager APIs to set the TCU activity state in ACTIVE mode
Using TCU Activity Manager APIs to set the TCU activity state in PASSIVE mode
▼
thermal
Using Thermal Manager APIs
Using Thermal Shutdown Manager APIs to get Thermal autoshutdown mode updates
Using Thermal Shutdown Manager APIs to set Autoshutdown modes