Please follow below steps to create Vlan and bind it to PDN

1. Get the DataFactory and VlanManager instances

auto &dataFactory = telux::data::DataFactory::getInstance();

auto dataVlanMgr = dataFactory.getVlanManager(opType);

2. Check if data subsystem is ready

bool subSystemsStatus = dataVlanMgr->isSubsystemReady();

2.1 If data subsystem is not ready, wait for it to be ready

Data subsystems is to make sure that device is ready for services like create and remove Vlan. if subsystems were not ready, wait for unconditionally.

if(!subSystemsStatus) {
   std::future<bool> f = dataVlanMgr->onSubsystemReady();
   subSystemsStatus = f.get();
}

3. Implement callback for create Vlan

auto respCbCreate = [](bool isAccelerated, telux::common::ErrorCode error) {
   std::cout << std::endl << std::endl;
   std::cout << "CALLBACK: "
               << "createVlan Response"
               << (error == telux::common::ErrorCode::SUCCESS ? " is successful" : " failed")
               << ". ErrorCode: " << static_cast<int>(error);
   std::cout << " Acceleration " << (isAccelerated ? "is allowed" : "is not allowed") << "\n";
};

4. Create Vlan based on interface type, acceleration, and assigned id

telux::data::VlanConfig config;
config.iface = infType;
config.vlanId = vlanId;
config.isAccelerated = isAccelerated;
dataVlanMgr->createVlan(config, respCbCreate);

5. Response callback will be called for the createVlan response

6. Implement callback for bindWithprofile reponse

auto respCbBind = [](telux::common::ErrorCode error) {
   std::cout << std::endl << std::endl;
   std::cout << "CALLBACK: "
               << "bindWithProfile Response"
               << (error == telux::common::ErrorCode::SUCCESS ? " is successful" : " failed")
               << ". ErrorCode: " << static_cast<int>(error) << std::endl;
};

7. Bind created Vlan with user provided profile id

dataVlanMgr->bindWithProfile(profileId, vlanId, respCbBind);