Forums - Autonomous flight

1 post / 0 new
Autonomous flight
Join Date: 27 Dec 19
Posts: 1
Posted: Sun, 2020-05-17 02:29

Dear all,

I am a newbie in this area and followed this instructor from :

I tried to take off the model but it always flip on one side

I finished all the previous step in the such as:

  1. Upgrading your Board Support Package
  2. BSP Recovery via SD Card
  3. Machine Vision SDK Setup Guide
  4. Navigator SDK Setup Guide
  5. Cross Compiler SDK Setup Guide

Before flight, I also used SNAV simualtion mode and watched X,Y,Z value(it run perfect).

Are there anything that I should do? 

Thank you all. 


  • Up0
  • Down0

Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.