In the QCA9377-7 datasheet, I can not find clearly where are the GPIOs pins used for SPI and I2C.
The datasheet document below birefly mentions GPIO[9] but can not find the full SPI signals (MISO, MOSI, SCK, SC). and the same for I2C?
Any information about this is appreciated.
80-WL431-300.book (qualcomm.com)
Thanks
Hi hossamf,
On this forum, we only support QCA9377-3/SDIO.
I see your question is for QCA9377-7/USB. We can make an exception and try helping you as much as possible.
Do you want to use SPI/I2C to communicate with QCA9377?
Thanks.