Hello expert,
I have QCA4020 M20 module mounted on a custome board. the QCA4202 M20 JTAG and USB interfaces are exposed in addition to many GPIOs. I can flash using EDL and USB port.
I want to flash the "Hello World" application using the JTAG interface. I have J-Link and tried to use it to flash to QCA4020 M20 module but no luck.
do you have detailed instructions and setup how to use J-LINK JTAG for flashing to the QCA4020 M20?
Thanks
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
