Hi All
I have a production ongoing where Im using the Blue test 3 suite together with the USB to SPI Babel-fish Programmer.
This is used to program some BC3 and BC8 products like CSR8811, ect.
In production setup Im using both PStool and Blue test for setup.
In a new setup Im planning to expand to parallel lines where I have looked at DK-USB-SPI-10225-1A programming kit instead of the babel-fish due to cost.
Any Idea if this will work with the Blue suite, like PS-tool and Bluetest3 with the 8811 chips, since in the datasheet is only mention uENERGY chips. ?
BR Soren
Hi,
The DK-USB-SPI-10225-1A board will allow you to use PSTools and BlueTest3 over the debug SPI transport, however note that this board requires that the PIOs are at 3.0V, if not then you will need external level shifters if VDD_PADS on your design is not at 3.0V.
Regards,
Ok, thanks for the quick feedback. so the VDDIO pin on eval PCB is set to 3V0, sinse all my products are running 1V8 as VDDIO. ?
BR SB
Yes, the VDD_PADS rail on the DK-USB-SPI-10225-1A programming board is at 3.0V which means the IO's are at 3.0V. If your design has the IO at 1.8V, then you will need an external level shifter.
We have another Babel called the "flat babel" (search for DK-CSR1000-10086-1A on Digikey) which gives you the option to select between 1.8V or 3.3V for the debug SPI connection but this kit is a bit more than the lower cost version of the programmer.
Regards,
Hi Liem
Ok, thanks for the quick support.
BR Søren
<p>I would like to know the function or the meaning of each terminlas of Debug SPI Header.</p><p>Could you show them to me?</p>