Hello,
In the hardwar specification it is mentioned "7 GPIOs of the local K22F MCU exposed to the Freedom connector" and I would like to know the details of the same. Can you please provide the pin out details ?
Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.
Thank you very much. I have couple of more questions. I am assuming the Freedom/Arduino pin out of K22 MCU will be as mentioned in the following link (Page 16 / Section 15 - Input/output connectors)
http://cache.freescale.com/files/microcontrollers/doc/user_guide/FRDMK22FUG.pdf
Is my assumption right ? Because the the 5V output and GND is *NOT* as per the document. I could *NOT* find the 5v output and GND. It will be of great help if you please give the pinout details of Freedom/Arduino connector as well. Thanks in advance.
since you asked this question in another forum - thread pls see my reply there
BR,
Oran