Forums - UART break signal and baud rate

2 posts / 0 new
or Register
Last post
UART break signal and baud rate
raniglas
Join Date: 21 Jan 20
Posts: 7
Posted: Thu, 2020-01-30 14:32
Top

Hi,

We require the use of a break signal on the Debug UART and support for 921600 baud rate on the HS UART.

Unfortunately, we were not able to find a way to support these using the QAPI calls.

Can you assist?

Is there any way we can access the QAPI code and make the necessary modifications or directly access the UART hardware to activate these functions?

Many thanks,

Rani 

  • Up0
  • Down0
Re: UART break signal and baud rate
c_rpedad
Profile picture
Join Date: 18 Jun 18
Location: San Jose
Posts: 317
Posted: Tue, 2020-02-11 14:06
Top

Unfortunately, we dont provide QAPI source access to the developer forum.
Currently UART break and 921600 baud rate are not supported.

  • Up0
  • Down0
or Register

Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.