Forums - EEPROM programming

2 posts / 0 new
or Register
Last post
EEPROM programming
Sergey Antonenko
Join Date: 3 Jun 16
Posts: 3
Posted: Thu, 2017-01-26 22:02
Top

Hi,

I need to programm firmware to CSR1010 EEPROM through SPI (as xIDE does) but without using CSR tools. I need to do it from connected (by SPI) ARM processor (runing natively without linux). Is it possible? I found no documentation about EEPROM programming through SPI.

On csrsupport.com I found csr1k_host_boot_00_01 example, it works, but writing only to CSR1010 RAM.

The only way I see now is to create bootloader programm, it will receive firmware dump from SPI and write it to EEPROM. To run bootloader I can use mechanism, implemented in csr1k_host_boot_00_01 example. Is this way correct? Maybe there is an easier way?

  • Up0
  • Down0
Re: EEPROM programming
Dr. Nissim Zur
Profile picture
Join Date: 6 Jun 16
Location: Skype: nissim.test CSR1010 External design house
Posts: 235
Posted: Mon, 2017-04-24 07:05
Top

call my Skype nissim.test 

I will help

  • Up0
  • Down0
or Register

Opinions expressed in the content posted here are the personal opinions of the original authors, and do not necessarily reflect those of Qualcomm Incorporated or its subsidiaries (“Qualcomm”). The content is provided for informational purposes only and is not meant to be an endorsement or representation by Qualcomm or any other party. This site may also provide links or references to non-Qualcomm sites and resources. Qualcomm makes no representations, warranties, or other commitments whatsoever about any non-Qualcomm sites or third-party resources that may be referenced, accessible from, or linked to this site.